Sienna AWD V6-3.3L (3MZ-FE) (2004)
6. REMOVE TRANSFER RH BEARING RETAINER OIL SEAL
a. Using SST, remove the RH bearing retainer oil seal.
SST 09308-00010
NOTICE: Do not damage the oil-seal-fitted surface of the case.
7. INSTALL TRANSFER RH BEARING RETAINER OIL SEAL
a. Using SST, drive a new oil seal into the case to the position shown in the illustration.
SST 09223-46011
NOTICE: Do not install the oil seal obliquely.
b. Apply small amount of MP grease to the oil seal lip.
8. INSTALL FRONT DRIVE SHAFT ASSY RH
9. INSTALL FRONT WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft. lbs.)
10. ADD AUTOMATIC TRANSAXLE FLUID
11. INSPECT AUTOMATIC TRANSAXLE FLUID
12. INSTALL TRANSFER DRAIN PLUG
a. Install the drain plug with a new gasket.
Torque: 49 Nm (500 kgf-cm 36 ft. lbs.)
13. INSTALL TRANSFER CASE NO.1 PLUG
a. Supply oil up to the level 0 - 5 mm (0 - 0.20 inch) below the lowest end of the plug hole.
Oil quantity: 0.9 L (0.95 US qts., 0.71 Imp. qts.)
NOTICE: When supplying oil, fill it slowly.
b. Install the plug No. 1 with a new gasket.
Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)
14. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
15. CHECK ABS SPEED SENSOR SIGNAL