Sienna AWD V6-3.3L (3MZ-FE) (2004)
4. Remove the front door trim board sub-assembly.
A. Remove the 3 screws and back frame plate.
B. Remove the 2 cushion rubbers.
C. Remove the 2 screws and clip A.
D. Using the plastic pry tool disengage the 9 remaining clips.
E. Remove the trim board by pulling upward.
F. Disconnect the 2 cables from the inside handle as shown in the illustration.
NOTICE
To prevent the door panel from being damaged, cover the areas indicated by arrow marks in the illustration with protective tape.
G. Using the plastic pry tool disengage the 10 hooks and remove the inner weatherstrip.
H. Remove the 2 screws and inside handle.