Sienna AWD V6-3.5L (2GR-FE) (2007)
/Page-1848002.png)
a. Put protective tape under the rear door glass weatherstrip.
b. Using a screwdriver or moulding remover, remove the rear door glass weatherstrip.
HINT: Tape the screwdriver tip before use.
INSTALLATION
1. INSTALL REAR DOOR GLASS WEATHERSTRIP
a. Install the rear door glass weatherstrip.
2. INSTALL SLIDE DOOR WINDOW ASSEMBLY
3. INSTALL REAR DOOR GLASS RUN
4. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
5. INSTALL SIDE TRIM BOARD COVER REAR
6. INSTALL REAR DOOR WINDOW FRAME SUB-ASSEMBLY
7. INSTALL REAR WINDOW SIDE GARNISH ASSEMBLY
