Sienna AWD V6-3.5L (2GR-FE) (2007)
4. REMOVE CRANKSHAFT PULLEY
(a)
Using SST, loosen the crankshaft pulley bolt.
SST 09213-70011 (09213-70020), 09330-00021
(b) Using SST, remove the crankshaft pulley bolt and crankshaft pulley.
SST 09950-50013 (09951-05010, 09952-05010, 09953-05020, 09954-05021)
5. REMOVE TIMING CHAIN CASE OIL SEAL
(a)
Using a screwdriver, pry out the oil seal.
HINT: Tape the screwdriver tip before use.
NOTICE: After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.
INSTALLATION