Sienna AWD V6-3.5L (2GR-FE) (2007)
7. REMOVE BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE
8. REMOVE LICENSE PLATE LIGHT ASSEMBLY
a. Release the 2 claw fittings and disconnect the license plate light assembly.
b. Disconnect the connector and remove the license plate light assembly.
INSTALLATION
1. INSTALL LICENSE PLATE LIGHT ASSEMBLY
2. INSTALL BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE
3. INSTALL BACK DOOR TRIM BOARD ASSEMBLY
4. INSTALL BACK DOOR PULL STRAP
5. INSTALL BACK DOOR STRAP COVER
6. INSTALL BACK DOOR SIDE GARNISH RH
7. INSTALL BACK DOOR SIDE GARNISH LH
8. INSTALL BACK DOOR GARNISH CENTER