Sienna AWD V6-3.5L (2GR-FE) (2007)
Tire Pressure Warning Reset Switch: Service and Repair
TIRE PRESSURE WARNING RESET SWITCH
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE FRONT DOOR SCUFF PLATE LH
3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
5. REMOVE TIRE PRESSURE WARNING RESET SWITCH
(a)
Disengage the 2 claws and remove the tire pressure warning reset switch from the lower instrument panel finish panel sub-assembly LH.
INSPECTION
1. INSPECT TIRE PRESSURE WARNING RESET SWITCH
(a)
Remove the tire pressure warning reset switch.
(b) Measure the resistance between terminals 1 and 2 of the tire pressure warning reset switch when the tire pressure warning switch is ON and
OFF.
Standard Resistance
If the result is not as specified, replace the tire pressure warning reset switch.
INSTALLATION