Sienna AWD V6-3.5L (2GR-FE) (2007)
Wiring Diagram
INSPECTION PROCEDURE
NOTE:
-
Turn the ignition switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
-
After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
-
Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches, or the
doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.
HINT: Operating the ignition switch, any switches, or any doors triggers related ECU and sensor communication with the CAN. This communication
will cause the resistance value to change.