Sienna AWD V6-3.5L (2GR-FE) (2007)
/Page-789004.png)
a. Using SST, install the heated oxygen sensor.
SST 09224-00010
Torque:
40 Nm (408 kgf.cm, 30 ft. lbs.) for use with SST
44 Nm (449 kgf.cm, 32 ft. lbs.) for use without SST
b. Connect the heated oxygen sensor (for Bank 1 Sensor 2) connector.
HINT:
-
Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
-
Make sure that SST and a wrench are connected in a straight line.
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. INSPECT FOR EXHAUST GAS LEAK
