Sienna AWD V6-3.5L (2GR-FE) (2007)
/Page-854003.png)
a. Install the VVT sensor with the bolt.
Torque: 10 Nm (102 kgf.cm, 7 ft. lbs.)
b. Connect the VVT sensor connector.
4. INSTALL VVT SENSOR (for Bank 1 Intake Side)
a. Install the VVT sensor with the bolt.
Torque: 10 Nm (102 kgf.cm, 7 ft. lbs.)
b. Connect the VVT sensor connector.
5. INSTALL INTAKE AIR SURGE TANK ASSEMBLY
6. INSTALL AIR CLEANER CASE SUB-ASSEMBLY
7. INSTALL AIR CLEANER CAP SUB-ASSEMBLY
8. INSTALL NO. 1 AIR CLEANER INLET
9. INSTALL NO. 2 AIR CLEANER INLET
10. ADD ENGINE COOLANT
11. INSPECT FOR ENGINE COOLANT LEAK
12. INSPECT FOR ENGINE OIL LEAK
13. INSTALL V-BANK COVER SUB-ASSEMBLY
14. INSTALL FRONT OUTER COWL TOP PANEL SUBASSEMBLY
15. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY
