Sienna AWD V6-3.5L (2GR-FE) (2007)
Variable Valve Timing Actuator Position Sensor: Service and Repair
REMOVAL
1. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
2. REMOVE FRONT OUTER COWL TOP PANEL SUBASSEMBLY
3. DRAIN ENGINE COOLANT
4. REMOVE V-BANK COVER SUB-ASSEMBLY
5. REMOVE NO. 2 AIR CLEANER INLET
6. REMOVE NO. 1 AIR CLEANER INLET
7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY
8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY
9. REMOVE INTAKE AIR SURGE TANK ASSEMBLY
10. REMOVE VVT SENSOR (for Bank 1 Intake Side)
a. Disconnect the VVT sensor connector.
b. Remove the bolt and VVT sensor.
11. REMOVE VVT SENSOR (for Bank 1 Exhaust Side)
a. Disconnect the VVT sensor connector.
b. Remove the bolt and VVT sensor.
12. REMOVE VVT SENSOR (for Bank 2 Intake Side)
a. Disconnect the VVT sensor connector.
b. Remove the bolt and VVT sensor.