Sienna AWD V6-3.5L (2GR-FE) (2007)
(c)
Remove the bolt and separate the brake tube from rear axle beam assembly.
13. SEPARATE REAR BRAKE TUBE NO.1
SST 09023-00101
HINT: Separate the RH side by the same procedures as the LH side.
14. REMOVE FUEL TANK FILLER HOSE COVER
(a)
Remove the 2 bolts, 3 screws, 3 nuts and fuel tank filler pipe protector.
(b) Remove the 3 bolts and fuel tank filler hose cover.
15. REMOVE REAR FLOOR NO.2 CROSSMEMBER BRACE LH
(a)
Remove the 2 bolts and floor No.2 crossmember brace.
16. REMOVE REAR FLOOR NO.2 CROSSMEMBER BRACE RH
HINT: Remove the RH side by the same procedures as the LH side.
17. LOOSEN REAR AXLE BEAM ASSEMBLY
(a)
Refer to hint below.
HINT: Loosen the RH side by the same procedures as the LH side.
NOTICE:
^
When loosening the bolt, hold the nut not to rotate.
^
Do not remove the bolt and nut.
18. SEPARATE SHOCK ABSORBER ASSEMBLY REAR LH
(a)
Support the rear axle beam assembly with a jack.