Sienna AWD V6-3.5L (2GR-FE) (2007)
(c)
Using a spanner to make the steering knuckle LH horizontal, fix it to the V block, as shown in the illustration.
NOTICE: Be sure the steering knuckle is horizontally positioned.
(d) Using SST(s) and a press, remove the front axle hub LH bearing.
SST 09950-60010 (09951-00600), 09950-70010 (09951-07100)
REASSEMBLY
1. INSTALL FRONT AXLE HUB LH BEARING
(a)
Using SST(s) and a press, install a new front axle hub LH bearing to the steering knuckle LH.
SST 09950-60020 (09951-00810), 09950-70010 (09951-07100)
2. INSTALL DISC BRAKE DUST COVER FRONT LH
(a)
Place the disc brake dust cover front LH and using a torx wrench (T30), torque the 4 bolts.
Torque: 8.3 Nm (85 kgf-cm, 74 inch lbs.)
HINT: Torx is a registered trademark of Textron Inc.
3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
(a)
Using SST(s), and a press, install the front axle hub sub-assembly LH.
SST 09608-32010, 09950-60020 (09951-00810), 09950-70010 (09951-07100)
4. INSTALL FRONT AXLE HUB LH HOLE SNAP RING