Sienna FWD V6-3.5L (2GR-FE) (2009)
(a) Remove the No. 1 ultrasonic sensor retainer as shown in the illustration.
6. REMOVE NO. 1 ULTRASONIC SENSOR
(a) Disconnect the connector and remove the No. 1 ultrasonic sensor.
Installation
PARK ASSIST / MONITORING: NO. 1 ULTRASONIC SENSOR: INSTALLATION
INSTALLATION
1. INSTALL NO. 1 ULTRASONIC SENSOR
(a) Connect the connector and install the No. 1 ultrasonic sensor.
2. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER
(a) Install the No. 1 ultrasonic sensor retainer.
3. INSTALL REAR BUMPER COVER See: Body and Frame/Bumper/Rear Bumper/Service and Repair/Installation
4. INSTALL FRONT BUMPER COVER See: Body and Frame/Bumper/Front Bumper/Service and Repair/Installation
5. INSTALL FRONT FENDER LINER LH
6. INSTALL FRONT FENDER LINER RH