Sienna FWD V6-3.5L (2GR-FE) (2009)
/Page-1323003.png)
(b) Install the sensor harness clamps with the 2 bolts A and B to the body and shock absorber.
Bolt A - Torque: 8.0 Nm (82 kgf-cm, 71in-lbf)
Bolt B - Torque: 19 Nm (192 kgf-cm, 14ft-lbf)
NOTICE: Do not twist the sensor wire when installing the sensor.
(c) Connect the clamp to the knuckle.
(d) Install the sensor harness and clamp to the body.
(e) Connect the speed sensor connector.
2. INSTALL FRONT FENDER LINER LH
3. REMOVE FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76ft-lbf)
4. CHECK ABS SPEED SENSOR SIGNAL
HINT: See: Antilock Brakes / Traction Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/ABS (Antilock
Brake System)/Test Mode Procedure
