Sienna FWD V6-3.5L (2GR-FE) (2009)
B. Adjust the center height of the reflector (SST P/N: 09870-60000) 48 mm (1-7/8 in.) higher than the measurement taken for the center of the
luminous portion of the laser sensor.
SST P/N: 09870-60000
NOTE
Adjust the height as precisely as possible.
C. From the center of the front and rear bumpers hang down the sharp-pointed weight and mark the center points of the vehicle on the ground (both
front and rear).
D. Attach one end of the string to the rear center mark and adjust the other end so that the string will line up with the front center mark of the
vehicle. Make a mark 5 m (16.5 ft) from the front of the vehicle where the string and the front vehicle center mark intersect.
E. From the 5 m (16.5 ft) marked position, measure the appropriate offset distance (listed in table below) to the right and place the reflector there.
NOTE