Sienna FWD V6-3.5L (2GR-FE) (2009)
(f) Using SST, install the oil filter cap.
SST: 09228-06501
Torque: 25 Nm (255 kgf-cm, 18ft-lbf)
NOTICE: Make sure that there is no clearance between the parts after tightening the oil filter cap.
(g) Apply a light coat of engine oil to a new O-ring and install it to the oil filter cap.
NOTICE: Remove all dirt and foreign matter from the installation surface.
(h) Install the oil filter drain plug to the oil filter cap.
Torque: 13 Nm (127 kgf-cm, 10ft-lbf)
NOTICE: Make sure that the O-ring does not get caught between the parts.
4. ADD ENGINE OIL
(a) Add clean engine oil and install the oil filler cap.
Engine oil:
Capacity:
5. INSPECT FOR OIL LEAK
(a) Start the engine. Check for engine oil leaks from the connected parts of the oil filter cap and oil filter drain plug.