Sienna FWD V6-3.5L (2GR-FE) (2009)
/Page-636001.png)
Variable Valve Timing Actuator Position Sensor: Testing and Inspection
2GR-FE ENGINE CONTROL SYSTEM: VVT SENSOR: ON-VEHICLE INSPECTION
ON-VEHICLE INSPECTION
1. CHECK VVT SENSOR OUTPUT VOLTAGE
(a) Turn the ignition switch to ON.
(b) Check the voltage between the specified terminal and body ground.
Standard voltage:
(c) While turning the crankshaft pulley by hand, measure the voltage between each terminal. Check that the voltage changes between the High
range and Low range shown in the table below.
Standard voltage:
