Sienna FWD V6-3.5L (2GR-FE) (2009)
Tire Pressure Module: Service and Repair
Installation
TIRE AND WHEEL: TIRE PRESSURE WARNING ECU: INSTALLATION
INSTALLATION
1. INSTALL TIRE PRESSURE WARNING ECU
(a) Connect the connector to the tire pressure warning ECU.
(b) Install the tire pressure warning ECU with the screw.
2. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
HINT: Refer to the instructions for INSTALLATION of the instrument panel safety pad See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair/Installation.
3. CONNECT CABLE TO BATTERY NEGATIVE TERMINAL
4. REGISTER TRANSMITTER ID
HINT: See: Tire Monitoring System/Testing and Inspection/Programming and Relearning/Registration.
5. INSPECT TIRE PRESSURE WARNING SYSTEM
HINT: See: Tire Monitoring System/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.
6. INITIALIZE SYSTEM
NOTICE:
-
Be sure to register the transmitter IDs of all tires in the ECU before initialization.
-
Be sure to inflate all tires to the proper inflation pressure before initialization.
HINT: See: Tire Monitoring System/Testing and Inspection/Programming and Relearning/Initialization.