Sienna FWD V6-3.5L (2GR-FE) (2009)
/Page-881009.png)
(a) Measure the resistance according to the value(s) in the table below.
Standard resistance:
NG -- REPAIR OR REPLACE CAN BUS MAIN WIRE OR CONNECTOR (CAN JUNCTION CONNECTOR - ECM)
OK -- REPLACE WIRING HARNESS CONNECTOR (CAN JUNCTION CONNECTOR)
Short in CAN Bus Lines
CAN COMMUNICATION: CAN COMMUNICATION SYSTEM: Short in CAN Bus Lines
Short in CAN Bus Lines
DESCRIPTION
The CAN bus wires are considered to be shorted when the resistance between terminals 6 (CANH) and 14 (CANL) of the DLC3 is below 54 Ohms.
WIRING DIAGRAM
