Sienna FWD V6-3.5L (2GR-FE) (2009)
C. Install the floor anchor with the bolt.
Torque: 42 N*m (430 kgf*cm, 31 ft*lbf)
D. Install the floor anchor cover.
E. Check the ELR lock.
NOTICE
The check should be performed with the assembly installed.
Check that the belt locks when pulling out the belt quickly when the belt is installed.
If operation is NOT as specified replace the front seat outer belt assembly.
F. Check the fastening function of the lock mode for the child restraint systems.
NOTICE
The check should be performed with the assembly installed.
(1) Check that the belt cannot be pulled out any more but can be rewound after the belt is fully pulled out.
(2) Check that the belt can be pulled out and rewound after the belt is fully rewound. If operation is NOT as specified replace the front seat outer
belt assembly.
7. Install the center pillar lower garnish.
8. Install the front door weatherstrip.
9. Install the rear door weatherstrip.
10. Install the front door scuff plate.
11. Install the rear door scuff plate.
12. Install the front seat assembly.
HINT
Refer to the Repair Manual instructions for each type of seat assembly.
Refer to TIS, applicable model year Sienna Repair Manual:
13. Re-install the instrument panel.