Sienna FWD V6-3.5L (2GR-FE) (2009)
(b) Install the No. 1 rear seat outer belt assembly with the 2 bolts and 3 nuts.
Nut - Torque: 4.0 Nm (41 kgf-cm, 35in-lbf)
Bolt - Torque: 42 Nm (430 kgf-cm, 31ft-lbf)
(c) Check the ELR lock.
NOTICE: The check should be performed with the assembly installed.
(1) Check that the belt locks when pulling out the belt quickly when the belt is installed.
HINT: The seat belt does not lock when the pull out amount of the belt is 955 mm (37.60 in.) or less. If operation is not as specified, replace
the No. 1 rear seat outer belt assembly.
(d) Check the fastening function of the child restraint system.
NOTICE: The check should be performed with the assembly installed.
(1) Check that the belt cannot be pulled out any more but can be rewound after it is fully pulled out.
(2) Check that the belt can be pulled out and rewound after the belt is fully rewound.
If operation is not as specified, replace the No. 1 rear seat outer belt assembly.
(e) Install the rear seat shoulder belt cover.
(f) Install the rear seatback board.
Components
SEAT BELT: REAR SEAT INNER BELT ASSEMBLY: COMPONENTS
COMPONENTS
ILLUSTRATION