Sienna FWD V6-3.5L (2GR-FE) (2009)
/Page-143001.png)
Distance Sensor: Technical Service Bulletins
Cruise Control - Laser Cruise Control Beam Adjustment
T-SB-0077-09
Rev1
March 2, 2009
Repair Manual Supplement: Laser Cruise Control Beam Adjustment
Service Category
Engine/Hybrid System
Section
Cruise Control
Market
USA
Applicability
TSB REVISION NOTICE
March 12, 2009 Rev1:
^
Figures 1, 3 and 4 have been changed in the Preparation Procedure. Any previous printed versions of this service bulletin should be discarded.
The information contained in this TSB supersedes TSB No. EL012-05.
^
Applicability has been updated to include 07-09 model years Avalon and Sienna vehicles.
TSB No. EL0122-05 is Obsolete and any printed versions should be discarded. Be sure to review the entire content of this service bulletin before
proceeding.
Introduction
When the laser cruise control sensor is removed from the vehicle for trouble diagnosis or repair it is necessary to adjust the laser beam axis after the
operation. Use the following procedure to perform laser cruise control beam axis adjustments.
Required Tools & Equipment
Additional TIS Techstream units may be ordered by calling Approved Dealer Equipment (ADE).
NOTE
Additional SSTs may be ordered by calling 1-800-933-8335.
