Sienna FWD V6-3.5L (2GR-FE) (2009)
/Page-1351002.png)
(d) Place the rotor shaft end into SST (A).
(e) Fit SST (B) to the clutch pulley.
(f) Loosen the pulley by turning SST (B) in the direction shown in the illustration.
NOTICE: Hold the generator assembly tightly.
(g) Remove the generator assembly from SST.
(h) Remove the clutch pulley from the rotor shaft.
2. REMOVE GENERATOR REAR END COVER
(a) Place the generator assembly on the clutch pulley.
(b) Remove the 3 nuts and generator rear end cover.
3. REMOVE GENERATOR TERMINAL INSULATOR
