Sienna FWD V6-3.5L (2GR-FE) (2009)
(a) Install the terminal insulator to the generator coil.
NOTICE: Pay attention to installation direction of the terminal insulator.
5. INSTALL GENERATOR REAR END COVER
(a) Install the generator rear end cover to the generator coil with the 3 nuts.
Torque: 4.6 Nm (47 kgf-cm, 41in-lbf)
6. INSTALL GENERATOR CLUTCH PULLEY
(a) Temporarily install the clutch pulley onto the rotor shaft.
(b) Set SST (A) and (B).
SST: 09820-63021
(c) Clamp SST (A) in a vise.
NOTICE: Be sure to fix the flat surface of SST (A) in a vise.