Sienna FWD V6-3.5L (2GR-FE) (2009)
(c) Reinstall the ST relay to the No. 3 relay block.
NG -- REPLACE ST RELAY
OK -- Continue to next step.
7. CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH - ST RELAY)
(a) Disconnect the P1 park/neutral position switch connector.
(b) Remove the ST relay from the No. 3 relay block.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance (check for open):
Standard resistance (check for short):
(d) Reconnect the park/neutral position switch connector.
(e) Reinstall the ST relay to the No. 3 relay block.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (PARK/NEUTRAL POSITION SWITCH - ST RELAY)
OK -- Continue to next step.
8. CHECK HARNESS AND CONNECTOR (ST RELAY - BODY GROUND)