Sienna FWD V6-3.5L (2GR-FE) (2009)
Steering Angle Sensor: Service and Repair
Installation
BRAKE CONTROL: STEERING ANGLE SENSOR: INSTALLATION
INSTALLATION
1. INSTALL STEERING ANGLE SENSOR
(a) Install the steering sensor onto the spiral cable.
2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
3. INSTALL SPIRAL CABLE SUB-ASSEMBLY See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and
Repair/Installation
4. INSTALL STEERING COLUMN COVER LWR See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and
Repair/Installation
5. CENTER SPIRAL CABLE See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair/Installation
6. INSTALL STEERING WHEEL ASSEMBLY
7. INSPECT STEERING WHEEL CENTER POINT See: Steering/Steering Column/Service and Repair/Removal and Replacement/Installation
8. INSTALL HORN BUTTON ASSEMBLY See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Installation
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
-
Make sure that the cable has been disconnected from the battery terminal for at least 2 seconds before reconnecting the cable.
-
Connect the cable to the negative (-) battery terminal with the front wheels facing straight ahead.
10. INSPECT SRS WARNING LIGHT
HINT: See: Restraint Systems/Air Bag Systems/Service Precautions.