Sienna FWD V6-3.5L (2GR-FE) (2009)
Seals and Gaskets: Service and Repair
Installation
U151E AUTOMATIC TRANSAXLE: DIFFERENTIAL OIL SEAL: INSTALLATION
INSTALLATION
1. INSTALL TRANSAXLE HOUSING OIL SEAL
(a) Using SST and a hammer, install a new oil seal.
SST: 09316-60011
09316-00011
Oil seal installation depth:
-0.5 to 0.5 mm (-0.020 to 0.020 in.)
(b) Coat the lip of the oil seal with MP grease.
2. INSTALL DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL
(a) Using SST and a hammer, install a new oil seal.
SST: 09223-15020
SST: 09950-70010
09951-07150
Oil seal installation depth:
-0.5 to 0.5 mm (-0.020 to 0.020 in.)
(b) Coat the lip of the oil seal with MP grease.
3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
HINT: See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal and Replacement/Installation
4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH (for 2WD)
HINT: See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal and Replacement/Installation
5. INSTALL FRONT WHEELS
Torque: 103 Nm (1,050 kgf-cm, 76ft-lbf)
6. ADD AUTOMATIC TRANSAXLE FLUID
7. INSPECT AUTOMATIC TRANSAXLE FLUID See: Service and Repair/Procedures
8. INSTALL ENGINE UNDER COVER NO.1
9. CHECK ABS SPEED SENSOR SIGNAL
HINT: See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes/Vehicle Stability Control System