Sienna LE V6-3.0L (1MZ-FE) (1998)
/Page-1457015.png)
16. Install rack guide spring cap lock nut.
a. Apply sealant to 2 or 3 threads of the nut.
Sealant: THREE BOND 1344, LOCTITE 242 or equivalent
b. Using SST 09631-10021, 09922-10010 to hold the rack guide spring cap, and using SST, torque the nut.
Torque: 50 Nm (37 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
c. Recheck the total preload.
Preload (turning): 0.8 - 1.4 Nm (6.9 - 12.2 inch lbs.)
d. Remove the RH and LH rack ends.
17. Install RH and LH claw washers and rack ends.
a. Install a new claw washer, and temporarily install the rack end.
HINT: Align the claws of the washer with the steering rack grooves.
b. Using a spanner (24 mm) to hold the steering rack steadily and using SST 09922-10010, torque the rack end.
Torque: 60 Nm (45 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
