Solara V6-3.3L (3MZ-FE) (2004)
d) Install the oil seal to the camshaft.
NOTICE:
^
Make sure the oil seal is installed facing the correct direction, as shown in the illustration.
^
Insert the oil seal until it cannot be pushed any further.
e) Remove any old packing material from the contact surface.
f) Apply seal packing to the No. 1 bearing cap as shown in the illustration.
Seal packing: Part No. 08826-00080 or equivalent
NOTICE:
^
Install the No. 1 bearing cap within 5 minutes after applying seal packing.
^
Do not expose the seal to engine oil for at least 2 hours after installing.
g) Install the 5 bearing caps in their proper locations.
h) Apply a light coat of engine oil on the threads of the bearing cap bolts.
i)
Uniformly tighten the 10 bearing cap bolts in the sequence shown in the illustration.
Torque: 16 Nm (163 kgf-cm, 12 ft. lbs.)
31. INSTALL CAMSHAFT