Solara V6-3.3L (3MZ-FE) (2004)
/Page-1362004.png)
a. Remove the outer belt.
1. Wind the seat belt with the retractor.
2. When the seat belt is sufficiently wound, cut the seat belt approximately 100 mm (0.39 in.) from the retractor, as shown in the illustration
HINT: The seat belt is designed so that winding the seat belt as much as possible before pretensioner activation will decrease the pulling
power of the seat belt during pretensioner activation.
b. Check if SST is functioning (see step 1-(a)).
CAUTION: When activating seat belt pretensioner, always use the specified SST.
SST 09082-00700, 09082-00770
c. Connect SST.
1. Connect SST, then connect the yellow connector to the seat belt pretensioner.
NOTE: To avoid damaging SST connector and wire harness, do not lock the secondary lock of the twin lock.
2. Place the outer belt on the ground and cover it with a tire with a wheel attached.
