Solara V6-3.3L (3MZ-FE) (2004)
Crankshaft Position Sensor: Service and Repair
REPLACEMENT
HINT: A bolt without a torque specification is shown in the standard bolt chart.
1. REMOVE ENGINE UNDER COVER RH
a. Remove the 5 screws, 3 clips and under cover.
2. REMOVE FRONT FENDER APRON SEAL RH
a. Remove the clip, 2 bolts and apron seal.
3. REMOVE CRANKSHAFT POSITION SENSOR
a. Disconnect the sensor connector.
b. Remove the bolt and sensor.
4. INSTALL CRANKSHAFT POSITION SENSOR
Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
5. INSTALL FRONT FENDER APRON SEAL RH
6. INSTALL ENGINE UNDER COVER RH