Solara V6-3.3L (3MZ-FE) (2004)
44. ADJUST TOTAL PRELOAD
a. Temporarily install the RH and the LH rack end sub-assy, in order to prevent the oil seal from being damaged by the rack teeth.
b. Using SST, torque the rack guide spring cap.
SST 09631-10021
Torque: 25 Nm (250 kgf-cm, 18 ft. lbs.)
c. Using SST, loosen the rack guide spring cap.
SST 09631-10021
d. Using SST, turn the control valve to right and left 1 or 2 times.
SST 09616-00011
e. Using SST, loosen the rack guide spring cap until the compression spring stops functioning.
SST 09631-10021
f.
Using SST and a torque wrench, tighten the rack guide spring cap until the preload falls within specifications.
SST 09616-00011, 09631-10021
Preload (turning): 1.2 to 1.5 Nm (12.2 to 15.3 kgf-cm, 10.6 to 13.3 inch lbs.)
g. Apply sealant to 2 or 3 threads of the rack guide spring cap lock nut.
Sealant: Part No. 08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent
h. Temporarily install the rack guide spring cap lock nut.