Solara V6-3.3L (3MZ-FE) (2004)
3) Place SST onto the inboard joint boot LH No.2 clamp.
SST 09521-24010
4) Tighten the SST so that the inboard joint boot LH No.2 clamp is pinched.
NOTICE: Do not overtighten the SST.
5) Using SST, measure the clearance of the inboard joint boot LH No.2 clamp.
SST 09240-00020
Clearance: 1.9 mm (0.075 inch) or less
NOTICE: When the measured value is greater than the specified value, retighten the clamp.
40. INSTALL FRONT AXLE INBOARD JOINT BOOT LH CLAMP
a) Install new inboard joint boot clamps.
1) Hold the drive shaft lightly in a soft vise.
2) Install 2 new inboard joint boot clamps to the boot.
3) Place SST onto the inboard joint boot LH clamp.
SST 09521-24010
4) Tighten the SST so that the inboard joint boot LH clamp is pinched.
NOTICE: Do not overtighten the SST.