Solara Coupe L4-2.4L (2AZ-FE) (2007)
Front Door Window Regulator: Technical Service Bulletins
Body - Power Window Initialization Procedure
PRE-DELIVERY SERVICE
PD030-06
Title:
INITIALIZATION OF DRIVER'S DOOR
POWER WINDOW DURING PDS
Models:
'07 Solara
May 24, 2006
Introduction
The driver's door power window must be initialized after installing the DCC fuse during Pre-Delivery Service (PDS).
The installation of the DCC fuse, and the initialization procedure shown below, will enable the ~one-touch open and close" and ~am protection"
functions for the power window of the driver's door.
NOTE:
Any time the battery terminal has been disconnected, the driver's door power window must be re-initialized.
Applicable Vehicles
^
2007 model year Solara vehicles.
Warranty Information
Initialization Procedure
1.
Turn the ignition switch to the "ON" position.
At this time, the power window switch for the driver's door window should be blinking.
2.
Push down and hold the driver's door power window switch to completely open the window.