Solara Coupe L4-2.4L (2AZ-FE) (2007)
![background image](/toyota/solara_coupe/l4-2.4l_(2az-fe)/Page-548001.png)
Crankshaft Position Sensor: Service and Repair
REMOVAL
HINT: A bolt without a torque specification is shown in the standard bolt chart.
1. REMOVE ENGINE UNDER COVER RH
a. Remove the 5 screws, 3 clips and under cover.
2. REMOVE FRONT FENDER APRON SEAL RH
a. Remove the clip, 2 bolts and apron seal.
3. REMOVE CRANKSHAFT POSITION SENSOR
a. Disconnect the sensor connector.
b. Remove the bolt, clamp and sensor.
INSTALLATION
1. INSTALL CRANKSHAFT POSITION SENSOR
Torque: 9.0 N.m (92 kgf.cm, 80 in.lbf)
2. INSTALL FRONT FENDER APRON SEAL RH
3. INSTALL ENGINE UNDER COVER RH