Solara Coupe V6-3.3L (3MZ-FE) (2008)
Repairs and Inspections Required After a Collision: Service and Repair
Center Airbag Sensor Assembly
SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY:
ON-VEHICLE INSPECTION
CAUTION: Be sure to perform the initialization of the occupant classification ECU if any of the following conditions occur (See:
Testing and Inspection/Programming and Relearning/Repair Instruction - Initialization). If the initialization is not performed, the
SRS may not operate properly.
-
The occupant classification ECU is replaced.
-
Accessories (seatback tray or seat cover, etc.) are installed to the vehicle.
-
The passenger seat is removed from the vehicle.
-
Both the SRS warning light and passenger airbag ON/OFF indicator light ("OFF") come on.
-
The vehicle is brought to the workshop for repair due to an accident or collision.
1. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check (See: Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC
Check / Clear).
2. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS NOT DEPLOYED)
(a) Perform a diagnostic system check (See: Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC
Check / Clear).
3. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED)
(a) Replace the center airbag sensor assembly (See: Air Bag Systems/Impact Sensor/Service and Repair/Center Airbag Sensor Assembly/Removal
).