Solara Coupe V6-3.3L (3MZ-FE) (2008)
/Page-1434004.png)
(a) Perform a diagnostic system check (See: Air Bag Systems/Service Precautions).
(b) With the front seat airbag assembly removed from the vehicle, perform a visual check including the following:
Cuts, Minute cracks or marked discoloration on the front seatback assembly around the front seat airbag assembly.
2. INSPECT FRONT SEAT SIDE AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS NOT DEPLOYED)
(a) Perform a diagnostic system check (See: Air Bag Systems/Service Precautions).
(b) With the front seat airbag assembly installed on the vehicle, perform a visual check including the following:
Cuts, minute cracks or marked discoloration on the front seat back assembly around the front seat airbag assembly.
-
Cuts, minute cracks or marked discoloration on the front seat airbag assembly.
-
Cracks or other damage to the wire harness or connector.
Occupant Classification ECU
SUPPLEMENTAL RESTRAINT SYSTEM: OCCUPANT CLASSIFICATION ECU:
ON-VEHICLE INSPECTION
Be sure to perform the initialization of the occupant classification ECU if any of the following conditions occur. If the initialization is not
performed, the SRS may not operate properly.
-
The occupant classification ECU is replaced.
-
Accessories (seatback tray or seat cover, etc.) are installed to the vehicle.
-
The passenger seat is removed from the vehicle.
-
Both the SRS warning light and passenger airbag ON/OFF indicator light ("OFF") come on.
-
The vehicle is brought to the workshop for repair due to an accident or collision.
1. INSPECT OCCUPANT CLASSIFICATION ECU (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check (See: Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC
Check / Clear).
2. INSPECT OCCUPANT CLASSIFICATION ECU (VEHICLE INVOLVED IN COLLISION)
(a) Perform a diagnostic system check (See: Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC
Check / Clear).
(b) Even if the airbag was not deployed, perform a visual check for damage to the occupant classification ECU including the following:
-
Cracks, dents or chips in the case.
-
Cracks or other damage to the connector.
Rear Airbag Sensor
SUPPLEMENTAL RESTRAINT SYSTEM: REAR AIRBAG SENSOR:
ON-VEHICLE INSPECTION
Be sure to perform the initialization of the occupant classification ECU if any of the following conditions occur. If the initialization is not
performed, the SRS may not operate properly.
