Supra L6-2997cc 3.0L DOHC MFI (1998)
b. Remove the master cylinder and gasket from the brake booster.
INSTALLATION
Installation is in the reverse order of removal.
1. Before installation, adjust length of brake booster push rod.
a. Install the gasket on the master cylinder.
b. Set the SST 09737-00010 on the gasket, and lower the pin until its tip slightly touches the piston.
c. Turn the (SST) upside down, and set it on the booster.
d. Measure the clearance between the booster push rod and pin head (SST).
Clearance: 0 mm (0 inch)
2. After installation, fill brake fluid and bleed brake system.
3. Check for leaks, check and adjust brake pedal.
