Supra L6-2997cc 3.0L DOHC MFI (1998)
Radiator: Service and Repair
Removal and Installation
REMOVAL
1. REMOVE ENGINE UNDER COVER
HINT: Start the engine, and check for coolant and A/T fluid leaks.
2. REMOVE BATTERY AND BATTERY TRAY
3. DRAIN ENGINE COOLANT
4. 2JZ-GTE: REMOVE NO.2 AIR TUBE
5. REMOVE NO.2 FAN SHROUD
a. Remove the 2 clips.
b. Disconnect the claw of the No.2 fan shroud from the hook of the No.1 fan shroud, and remove the No.2 fan shroud.
6. REMOVE AIR CLEANER DUCT
7. 2JZ-GTE: REMOVE NO.5 AIR HOSE
8. DISCONNECT HOSES FROM RADIATOR
Disconnect these hoses from the radiator:
1) Reservoir inlet hose
2) Upper radiator hose
3) Lower radiator hose
4) A/T:
2 oil cooler hoses
Plug the hose ends.
HINT: At the time of installation, please refer to the following items. Check the A/T fluid level.
9. REMOVE RADIATOR ASSEMBLY
a. 2JZ-GTE: Disconnect the Engine Coolant Temperature (ECT) switch (for electric cooling fan connector) and wire harness.
b. 2JZ -GTE: Disconnect the 2 electric cooling fan connectors and wire harness.
