Supra L6-2997cc 3.0L DOHC MFI (1998)
Torque: 226 Nm (166 ft. lbs.).
f.
Install the lower arm bracket stay.
Torque:
Nut: 43 Nm (32 ft. lbs.).
Bolt: 59 Nm (43 ft. lbs.).
g. Install the engine under cover.
6. Adjust toe-in.
a. Remove the boot clamps.
b. Loosen the tie rod end lock nuts.
c. Turn the left and right tie rod ends an equal amount to adjust the toe-in.
NOTE:
-
Make sure that the lengths of the left and right tie rods are the same.
-
Try to adjust the toe-in to the center value.
Tie rod end length left-right error: 1.5 mm (0.059 inch) or less.
d. Tighten the tie rod end lock nut.
Torque: 56 Nm (41 ft. lbs.).
e. Place the boot on the seat and clip it.
NOTE: Ensure that the boots are not twisted.
7. Inspect wheel angle.
Turning the steering wheel fully and measuring the turning angle.
Less Turbo (2JZ-GE):
Inside wheel:
35°00' (33°00' - 36°00').
35° (33° - 36°).
Outside wheel (reference): 30°45' (30.75°).
With Turbo (2JZ-GTE):
Inside wheel:
