Supra L6-2997cc 3.0L DOHC MFI (1998)
HINT: Match the bolt of the suspension support with the cut-out part of the insulator.
2. Install coil spring to shock absorber.
a. Using Special Service Tool (SST) 09727-30021 or equivalent, compress the coil spring.
NOTICE: Do not use an impact wrench, it will damage the SST.
b. Install the coil spring to the shock absorber.
HINT: Fit the lower end of the coil spring into the gap of the spring seat of the shock absorber.
3. Install suspension support.
a. Install the suspension support to the rod.
b. Temporarily tighten a new nut.
c. Turn the suspension support so that one of the bolts on the suspension support faces the same direction, as shown in the illustration.
HINT: Align the bolt so that a line drawn between the rod and the bolt would be 90° to the direction of the lower bushing.
d. Remove the SST.
HINT: After removing the SST, again check the direction of the suspension support.
