Supra L6-2997cc 3.0L DOHC MFI (1998)
c. Using a snap ring expander, install a new snap ring.
5. Assemble boots to joints.
Before assembling the boot, pack with only the same amount of grease that was wiped off.
Grease capacities:
Outer joint: 100 - 105 g (3.5 - 3.7 oz.).
Inner joint: 100 - 105 g (3.5 - 3.7 oz.).
HINT: Use the grease supplied in the boot kit.
NOTICE:
-
Keep grease off the joint connection groove of the boot.
-
Pack with grease all over the ball contact surface inside the joint.
6. Install new boot clamps to both boots.
a. Position the clamp onto the boot.
HINT: Pinch the inboard side of the boot clamp, as shown in the illustration.
b. Place SST 09521-24010 onto the clamp.
c. Tighten the SST so that the clamp is pinched.
NOTICE: Do not overtighten the clamp by the SST.
d. Using SST 092040-00020, adjust the clearance of the clamp.
Clearance: 0.8 mm (0.031 inch)
