Supra L6-3.0L DOHC Turbo (7M-GTE) (1987)
Alignment: Service and Repair
Front
Prior to checking and resetting front wheel alignment, check tire pressure to ensure it is correct, check wheel bearings for looseness and correct as
necessary and check wheel runout with a dial indicator. Wheel runout should not exceed .047 inch (1.2 mm).
CASTER & CAMBER
Fig. 5 Front camber/caster adjusting cam. Van w/4 wheel drive & Supra
Fig. 6 Rear camber/caster adjusting cam. Van w/4 wheel drive & Supra
W/4 Wheel Drive & Late 1986-88 Supra
Caster and camber are adjusted by rotating front and/or rear adjusting cams as shown, Figs. 5 and 6.
TOE IN, ADJUST
Measure length of tie rod on each side and adjust to be equal. Adjust toe-in by turning adjusting tubes equal amounts. Clamp adjusting tubes after