Supra L6-3.0L DOHC Turbo (7M-GTE) (1987)
3. INSTALL NEW DRIVEN GEAR AND PIN
(a) Align the matchmark with the groove of the housing.
(b) Align the drilled mark on the new driven gear with the groove of the housing.
(c) Using a punch and hammer, peen both ends of the pin.
INSTALLATION OF CAM POSITION SENSOR
1. CHECK NO.1 CYLINDER TO TDC COMPRESSION
2. INSTALL CAM POSITION SENSOR
(a) Install a new 0-ring to the cam position sensor.
NOTE: Always use a new 0-ring when installing the cam position sensor.
(b) Align the drilled mark on the driven gear with the groove of the housing.
(c) Insert the cam position sensor, aligning the center of the flange with that of the bolt hole on the cylinder head.
(d) Lightly tighten the hold-down bolt.