Supra Liftback L6-2997cc 3.0L DOHC MFI Twin-Turbo (1997)
Crankshaft Main Bearing Seal: Service and Repair
Seal Retainer Removed From Engine
1. Using a screwdriver and hammer, tap out the oil seal.
2. Using seal driver Special Service Tool (SST) No. 09223-15030, 09950-70010 (09951-07100), or equivalents, and a hammer, tap in a new oil seal
until its surface is flush.
3. Apply MP grease to the oil seal lip prior to installation.
4. Install rear oil seal retainer as follows:
A. Remove any old packing (FIPG) material:
(a) Be careful not to drop any oil on the contact surfaces of the retainer and cylinder block.
(b) Using a razor blade and gasket scraper, remove all the old packing (FIPG) material from the gasket surfaces and sealing groove.
(c) Thoroughly clean all components to remove all debris.
(d) Using a non-residue solvent, clean both sealing surfaces.
B. Apply seal packing Part No. 08826-00080, or equivalent, to the retainer as shown in the illustration:
(a) Install a nozzle that has been cut to a 2-3 mm (0.08-0.12 inch) opening.
(b) Parts must be assembled within 3 minutes of application. Otherwise the material must be removed and reapplied.
(c) Immediately remove nozzle from the tube and reinstall cap.
C. Install the retainer with the 6 bolts, tighten to 5.9 Nm (60 kg. cm., 52 inch lbs.)
