Supra Liftback L6-2997cc 3.0L DOHC MFI Twin-Turbo (1997)
(b) Slide on the timing pulley facing the flange side inward.
NOTE: Do not scratch the sensor part of the crankshaft timing pulley.
(c) Install the timing belt plate with the bolt and tighten to 7.8 Nm (80 kg. cm., 69 inch lbs.).
2. Install tensioner idler pulley as follows:
(a) Apply LOCTITE 242, or equivalent, adhesive to two or three threads of the pivot bolt.
(b) Using a ten mm hexagon wrench, install the plate washer and pulley with the pivot bolt and tighten to 34 N m (350 kg. cm., 25 ft. lbs.).
(c) Check that the pulley bracket moves smoothly.
3. Install timing belt to crankshaft sprocket as follows:
NOTE: The engine should be cold.
(a) Using the crankshaft pulley bolt, turn the crankshaft, and align the timing marks on the crankshaft timing pulley and on the oil pump body.
(b) Remove any oil or water on the crankshaft timing pulley and idler pulley, and keep them clean.
(c) Install the timing belt on the crankshaft timing pulley and idler pulley.
