Supra Liftback L6-2997cc 3.0L DOHC MFI Twin-Turbo (1997)
NOTE: Close vise until it holds hub bolt. Do not tighten further.
b. Using a hammer and chisel, loosen the staked part of the lock nut and remove it.
c. Remove the sensor rotor.
NOTICE: Take care not to scratch the serrations of the sensor rotor.
3. Remove axle hub from steering knuckle, as follows:
a. Remove the four bolts and shift the brake dust cover toward the hub side (outside).
b. Using Special Service Tool (SST) 09950 - 40010 (09951 - 04010. 09952 - 04010, 09953 - 04020, 09954 - 04010, 09955 - 04030, 09958 -
04010) or equivalents, remove the axle hub from the steering knuckle.
4. Remove the inner race (outside) from axle hub. Using the SST 09950 - 40010 (09951 - 04010, 09952 - 04010. 09953 - 04020, 09954 - 04010,
09955 - 04010, 09958 - 04010) or equivalent, remove the inner race (outside) from the axle hub.
5. Remove oil seal. Using SST 09308 - 00010 or equivalent, remove the oil seal from the steering knuckle.
6. Remove bearing from steering knuckle, as follows:
a. Using snap ring pliers, remove the snap ring.
b. Position the inner race above the bearing on the inner side.
