Supra Liftback L6-2997cc 3.0L DOHC MFI Twin-Turbo (1997)
NOTICE: Do not use an impact wrench, it will damage the SST.
b. Remove the suspension support nut.
c. Remove the suspension support, coil spring and insulator.
2. Remove insulator and spring bumper.
Remove the insulator and spring bumper from the suspension support.
ASSEMBLY
1. Install suspension support and coil spring, as follows:
a. Install the spring bumper to the suspension support.
b. Install the insulator to the suspension support.
NOTE: Match the bolt of the suspension support with the cut-off part of the insulator.
2. Install coil spring and suspension support, as follows:
a. Using Special Service Tool (SST) 09727-30020 or equivalent, compress the coil spring.
NOTICE: Do not use an impact wrench, it will damage the SST.
b. Install the coil spring to the shock absorber.
NOTE: Fit the lower end of the coil spring into the recess of the shock absorber's spring seat.
c. Install the suspension support to the rod and temporarily tighten a new nut.
d. Rotate the suspension support so that the rod and one of the bolts on suspension support are aligned with the lower bracket.
e. Remove the SST.
NOTE: After removing the SST, again check the direction of the suspension support.