Supra Liftback L6-2997cc 3.0L DOHC MFI Twin-Turbo (1997)
Drive/Propeller Shaft: Service and Repair
Removal
1. Remove oxygen sensor.
a. Remove the 2 bolts.
b. Remove the oxygen sensor and heat insulator.
2. Remove exhaust pipe.
a. Remove the 2 bolts on the transmission side.
b. Remove the 2 bolts, nuts and pipe support bracket.
c. Remove the 2 exhaust pipe support rings.
d. Remove the 2 exhaust pipe support O-rings.
e. Remove the front exhaust pipe.
f.
Remove the gasket.
3. Remove heat insulator. Remove the 4 nuts and heat insulator.
4. Remove center floor crossmember brace. Remove the 4 bolts and crossmember brace.
5. Remove propeller shaft.
a. Using Special Service Tool (SST) 09922-10010, or equivalent, loosen the adjusting nut until it can be turned by hand.
NOTE: Use 2 of the same type SST.
