Supra Liftback L6-2997cc 3.0L DOHC MFI Twin-Turbo (1997)
2. Temporarily install new boots and new boot clamps, as follows:
a. Place four new boot clamps to boots.
NOTE: Before installing the boots, wrap vinyl tape around the spline of the shaft to prevent damaging the boots.
b. Install two boots to the drive shaft.
3. Install inboard joint cover, as follows:
a. Apply Formed In Place Gasket (FIPG) to the inboard joint cover as shown in the illustration.
FIPG: Part No. 08826 - 00801, THREE BOND 1121 or equivalent.
-
Install a nozzle that is cut to 1 mm (0.04 inch) opening.
NOTE: Avoid applying an excessive amount to the surface.
b. Clean the surface of the inboard joint facing the cover.
c. Align the bolt holes of the cover with those of the inboard joint, then insert the hexagon bolts.
d. Use a plastic-faced hammer to tap the rim of the inboard joint cover in place. Do this in the order shown, and repeat several times.
4. Install inboard joint, as follows:
a. Align the matchmarks placed before removal.
b. Using a brass bar and a hammer, install the inboard joint onto the drive shaft.
NOTICE: Check that the brass bar is touching the inner race, and not the cage.
c. Using a snap ring expander, install a new snap ring.